Hey! Here is a fun Flying Saucer Succulent pot! I'm going to put some Ogre Ears (type of succulent) in it because they kind of look alien-esque. I printed this at 93% of full size to fit on my Select Mini printer (100% didn't quite fit the build plate in Cura). Print this in 3 parts; the top half, bottom half, and then the round feet. Print the top and bottom halves with the big sides on the build plate. I glued them all together with CA glue.
The full model with supports will print but it looks nasty on the bottom. I also forgot to fillet the edges where the legs intersect the bottom half on the full model (the bottom half model has the fillets).
Enjoy! Upload some pictures of your prints with your choice of succulent. I'm curious to see how these look.
Support angle 50 degrees. Skirt. 0.2625 mm layers. 1.05 mm wall.