This is a building you can use for any sort of tabletop game where you need cover. I created this to be used in my Battletech war games
- Update V2. I had to make some adjustments to the paper slot and to the bottom of the roof.
Also I found printing the base with a raft was helpful, and printing the roof without support worked in my first test. My first attempt with the base came off the print table, so when I setup the print I added a raft and that fixed it.
You can use both a 3D printer and normal ink printer to create this building. An extra page is included if you do not have a 3D printer which has the roof on it. I would recommend thicker stock paper.
Cut out the walls and fold on the lines as shown on the page. Leave the tabs on the end to overlap the walls when placing it into the 3D printed base. Once the walls are in place, place the roof over the walls. You can leave it like this, and disassemble after games, or glue it into place.
Place walls into base
Place roof onto walls