//If you do print this thing please post a make, and share your thoughts on this design.
Printed on Ender 3, 0.4 nozzle, 0.2 layer height.
After printing remove supports.
Components needed for assembly:
- 1x M3 Nut with nylon insert
- 1x Small M3 Washer
- 1x Short M3 Screw (M3x10mm or M3x12mm)
- 2x M3 Screws (M3x12mm)(Optional)
- Small spring ((Optional) I used one from a Pen)
Cheapest i could find PLA
This design is not exactly perfect and it needs tweaks, read below.
Tweak: After printing i took a lighter and warmed up tips of my pliers, then arched it as needed.