Loading
mysterme

The Orc Horde Based and Supported

by mysterme Dec 30, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

Can we possibly get these without supports. I tried a run on my resin printer and couldnt get the supports off without breaking the model.

This is not the greatest horde in the world, this is just a tribute. It's remixed from the supportless version :)

Ahh, then you need to credit the original in your post.

Thanks for this. I'm new to printing, so it's nice to have supports already made.

Would you care sharing your MeshMixer Settings for your overhang supports? I've been dabbling but still haven't perfected one yet.

I'm using:

Angle Thresh: 45
Contact Tol: 0
Y-Offset: 0
Max Angle: 45
Desnity: 80
Layer Height: .2
Post Diameter: 2
Tip Diameter: .4
Base Diameter: 3
uncheck allow top connections
Optimization: 0
Solid Min Offset: .02
Tip Height: 2
Base Height: .4
Strut Density: 0
Post Sides: 7

My problem is that sometimes I get WAY TOO MANY supports. Also, I haven't been able to figure out a way to manually place supports in Meshmixer.

But I liked some aspects of yours! Really good!

What settings do you use? And do you use only the generated supports

Which program did you use for those supports? They have been the best so far

Thanks, they were done in MeshMixer (free)

The orc spearman 1 will have problems. It doesn't have any support on the lower portion of the front skirt, in front of the left knee.

The print recovers, and that area ends up a little fuzzy. It's not the worst outcome, but not great.

Yes, you are correct, that skirt was more trouble to support than it is worth :(

This is definitely going to be my next set to print! Very curious to see how everything works with these supports. regular supports have been the bane of my miniature printing experience lately.

Hope they printed OK for you :)

These are awesome! Any chance I can get your Meshmixer settings? Just got the mk3 recently, and everything I’ve tried from there hasn’t worked out well, and these work beautifully!

Thanks for posting these. I didn't even know mesh mixer existed, and these prints are gorgeous with easy to remove supports.

These things are great! Thanks! I have one that is not able to print on its own. The sleeve of the Shamen could use some extra support because it ends up pretty wobbly when printing and causes the print to fail. Otherwise awesome set and appreciate the custom supports.

Yes, that is a bit undersupported, ill revisit it next time :)

Thank you! You took a great set of minis and made them even easier to print!

How difficult would it be for you to swap the bases out for square 20mm or 25mm bases? I can try my hand at it too. Thanks for remixing these! absolutely amazing. Im selling all my old orcs and going to use these. love the old school middle hammer feel