Remix of a coffee mug model to serve as an air-plant holder. It's been scaled down from the original model and has a magnet on the back so that it can be attached a refrigerator, cubicle, etc. Obviously it can be printed and used as a generic magnet as well.
The back of the mug has a cut-out for a 6.3mm neodymium magnet (available at most craft stores).
Not feeling like doing the printing and finishing work yourself? https://www.etsy.com/listing/650503060/coffee-mug-air-plant-magnets
Completed prints were cleaned, and had the magnet attached with a two-part epoxy.
After the epoxy has cured, the mugs were placed in a cold acetone vapor chamber for 30 minutes.