This is a small bowl holder designed to hold hot bowls. Pretty self explanatory. Duh.
I would recommend printing this at extremely low layer heights (mine was printed at 0.04 mm steps). This will really get the mesh to show. Make sure you have sufficient part cooling so you get a finished product with fewer overhangs and less stringing. If you don't, you will have to use supports. And those are a pain to get off of a model like this.
Mine was printed in color changing PLA. No post processing was needed other than cleaning up some minor overhangs with a small file.
Modeled using Maya and Meshmixer.
Don't Remember Color Changing PLA
Brown to Green