Loading
webwang1984

Creality Ender 3 Cam Holder for Time Lapse Video

by webwang1984 Jan 3, 2019
Download All Files

Thing Apps Enabled

Please Login to Comment

So I made this and a few things.

  1. I turned this 90 from how its shaped and while it printed, good luck getting supports out of the middle without braking off the cross supports which, I found out, you dont need at all. Stability wise they dont do anything and printing wise they just take up time.

  2. The backet on mine will hit the hot end casing if its too close, which means i have a limited space where i can put it and keep it there. If the top end part was offset on the mount by about 5mm it would clear the hot end. If you moved it back by about 3mm and shortened the whole unit by about 6mm then it would be short enough to fit under the autohome (if your x stop is all the way to the bottom like mine).

    Also, hot damn you have to take off the whole case just to get this thing on!

This is great. What orientation did you print it in, as is or is there a better way to print? Also i you moved the arm to sit flush with the closed end of the camera you might get away with a whole bunch of supports!

I tried with the mounting feature facing up. No much support material is needed to remove after the print. Good luck~~~