I am a happy owner of an Nvidia Shield TV 2018, but after using it for a few months, I came to the realization that the remote of this streaming player is so small and fragile. I had a mission then, which was to protect this remote at all cost. I was willing to purchase a case but no one made one. After spending countless amount of hours looking for a case for my remote on the internet, i was not able to find one so decided to make my own with my recent first 3D Printer Prusa I3 Mk3 purchase. I designed this in Sketchup since that's the only thing I know for now, I have printed both in PLA and PEGT without an issue. Once the remote is in and the cover is close, the remote is meant to stay inside without removing it. Batteries can reached through the cut out opening with a PIN easily.
Print the case upward for best results.
Support me here if you can, I'd appreciate it
It is a tight fit on the two pegs, i did not have to sand it down but slowly push it in and once you got a tiny bit in, you can give it a small bump until a tight flush. I also put painters tape inside for a tight fit so it does not rattle. One layer is enough