A LAN port cover for Lenovo Ideapad Laptop.
I worked quite a long time on this one. Taking the right measurements here was difficult.
The ethernet plug does not lock in place perfectly, but it is working. Maybe I will improve it later.
The original plastic cover breaks very fast, it isn't designed very well. The replacement part is way too overpriced (about 10€ on ebay).
This one is just the clamp, but the bottom part can be printed as well (haven't built it yet).
no name PETG
I printed it with support, maybe it is working without support as well.
I tested it with PETG, but PLA will do it also.