This is a remix of Andybx's Deer Decoration.
- Widened the antlers.
- Elongated the neck scruff for better printability without supports.
- Added a planting/airplant area on his back.
- Designed an organic forest floor with pee-river and pee-watered planter area. Planter area is roughly rectangular and ~30mm deep. Mostly for small succulents.
For print services, visit our Etsy storefront: https://printapot.etsy.com .
Brown and Green
Print the Moose with the Base model and merge within your slicer for proper alignment.
Made the base surface using a series of splines (10 splines) to setup an organic forest floor with bumps and mossy rocks. Used projections and intersections in each of the spline sketches to try to stick closely to my original simplified drawings.
After I set up a series of splines at different offset planes, I patch-mode lofted through the splines to create the surface.
Next, I added a patch to the bottom of the model in patch mode of Fusion 360. Then I stitched the patch to the forest floor surface to complete the body.