Loading
Jbrow532

Drink Can Insulator (Similar to Yeti Rambler Colster)

by Jbrow532 Jan 10, 2019
Download All Files

Thing Apps Enabled

Please Login to Comment

I have printed the bottom half without any issues, but have ran into a problem when printing the screw on lid... Every time it gets to the threaded part, the extruder moves slightly up and away from where it should be printing and squirts material all over the place...
Plastic spaghetti, I have tried two different slicers, lots of different settings, with and without support, I tried flipping the model upside down and printing it that way, still same issue. After 5 failed attempts with the exact same issue despite changing all available settings. I have lost hope in getting the lid to print correctly.

cra5h,

I'm sorry that the print has not worked for you. I intended for the model to be printed upside down, and with a relatively fine layer height for better adhesion and curvature. If you could, please send me a gcode file that you used for one of your attempts along with a screenshot of your settings, that way I can properly understand the problem and help you make use of the lower you have already printed.

Thanks