Minimalist slider wallet I've been working on to teach myself Fusion360. You don't need support for the finger hole in the base, only to the bottom of the money clip, if printed vertically. Feedback welcome!
24/01/19_v36: Enclosed the end of the base so the cards cannot slide back when opening. Should have started with it that way, just didn't want it to become too long needlessly. It's still shorter than most wallets, not sure what I was thinking...
I print the Base horizontally now, and the Cover vertically. Let me know if you find a better solution. Before I enclosed each end of the Base I printed both halves vertically, which worked fine, but creates a terrible "zziiipp!" noise when you open and close the wallet. Enjoy!