I was tired of losing the TV etc. remotes. I searched Thingiverse and saw some but none were what I had in mind. So I created this. Nice, compact and functional and very simple. Takes my 4 handsets and takes up very little coffee table table space. Looks great in black PLA. The proptotype was in ghastly purple, by special request unfortunately :-(
3 slots are 52 x 28 for Panasonic etc. The fourth a bit bigger to take the new Humax 'curvy' handset at 59 x32
Overall dimensions are 126 x 75 x 48
Printing at a nice steady good quality speed took about 6 hours to print! I'm sure it can be done faster but I like to get best possible quality finish.
PS if you look closely at the purple pics, there is some quality degradation near the top in the radius bevel edges. This was under extrusion caused by pesky bad spool winding causing a filament spool jam that I didn't notice until too late. Grrrrrr!
UPDATE: Inspired by the success of the 4x handset stand (done for a friend in purple at her request!!) I have now made a super deluxe 6 handset version. File included on here. Slot dimensions are same as above but with an additional full width slot for two more handsets added. This extra slot is 118 x 25. The whole thing is now an enlarged 126 x 103 x 48. I also added a couple of small blocks in the bottom of the front right 59 x 32 slot to improve the sitting angle of my Humax curvy handset.
This one took almost 9h to print (slow HQ settings) but looks really fantastic in black PLA. My best quality finished thing printed yet.
Unknown generic Ebay sourced PLA
Purple (and Black later)
None required. Lift off the plate and use.