The case on this radio is an Indian radio case and I had to turn the fan 90 degrees to fit it in. The radio case had the main power switch on the rear panel. UGGGH.... So I put a rocker switch on the front.
To ease printing I made the duct in two parts and used a 3d printing pen to glue the two halves together. My printing pen is a Wesen brand and got it on Amazon for less than 20 dollars. Using PLA to weld it, basically welds the two parts together.
I wired the fan to run full time. It is a very quiet
More from Electronics
Save to Dropbox
If you’re logged into Dropbox, you can save directly to Dropbox.
Show Some Love
Say thanks by giving _Dave a tip and help them continue to share amazing Things with
the Thingiverse community.
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.