Raspberry Pi 3 B+ Case

by mkellsy Jan 16, 2019
Download All Files

Thing Apps Enabled

Please Login to Comment

Hey, would it be possible to mount this onto the Ender 3? Also.. is it possible to have a cutout for the GPIO pins?

You might be able to to use the 8020 mount, however I don't have an Ender 3 so I can't say for sure.

There are cutouts for the gpio pins. Use snips to cut the breakout prices. You can open half or all gpio pins.

Haven't printed this yet but was looking for a case for my new B+ to use with "OpenMediaVault" NAS type device. All drives will be powered USB but wanted to keep the Pi a bit protected. Thanks.

Very nice looking 2 tone case.

A quick tip, I couldn't get the honeycomb pattern to print face down as a first layer on my Prusa MK3 with PETG but it worked perfectly printing on a 2 layer raft.


The honeycomb pattern is a torture test for bed adhesion. A raft is a great way to do this. I printed mine in PLA and I set the bed to 35c and used purple glue in a cross hatch pattern. I also set the layer one speed to 50%, this gives the layer time to stick. I also print on glass.

m3 screws should fit this as well right? I have those on hand ;)

The hole size for a M3 is 2.5 MM. The holes are 2.7 MM and 2.8 MM. So I think M3 screws should work fine.