A sponge holder for a two-parted sink. The bridge in the middle is 20-25mm, one side of the holder is 40mm wide, the other 60mm and it has a length of 120mm.
Be sure to print it standing up as shown in the picture to have it flexible and sturdy. Prints without support, don't enable supports in your slicer software or it might miscalculate some which are not needed.
To have no stringing at all, set "minimum travel distance for retraction" to 1mm in your slice software.
Other Settings in Slic3r:
- First Layer Height: 0.2mm
- Vertical Shells: 2
- Solid Top/Bottom Layers: 3
- All "Quality" Settings except "Avoid crossing perimeters"