Bullseye adjustable LED light bar
This is a lightbar with adjustable tilt angle for the original "Bullseye Hotend Cooler".
This is an LED light bar designed for the Bullseye at the URL:
1 screw is required from the computer case or other screw
Its made for a 2x12V-LED-Stripe (L-50mm x W-10mm), so you can plug it directly into the 24V PSU of a Ender 3. !!!You must necessarily solder 2 segments of 12 volt backlight in serial connection ("+" of the first tape to "-" of the second tape) as per image!!!
You can use 1 x 24V-LED-Stripe.
You also can wired the LED’s into the 40mm fan of Hot-end 24v power with a Dupont “Y” or soldering.
For better connection with Bullseye use superglue =)
Solidworks file available in archive!
i'm printing with supports "Touching buildplace", infil 80, speed 60, cooling after 1 layer and 200 degrees for PLA