Cover for the hotend for the Anycubic I3 Mega. This is a remix from two sources. I Have added vent holes on the front of the cover and removed bottom plate with "closing" housing to block air for ABS prints.
Finally I have added small hole onto a top left side to get out fan cable, because I'm going to use cooling blower attached from back of the hotend carriage.

I have provided also a stl with tree supports generated by meshmixer to save time and material if you decide to use this design.

Recommended to print in PET or ABS to avoid deformations by temperature.

Anycubic I3 Mega

Doesn't Matter

Yes

0.2

20%

If you want, use STL with supports generated by Meshmixer to save material and time :)