This is a rear hatch handle for the Redcat Gen 8 International Harvester Scout II scale crawler.
Additional hardware needed:
1pc: M2x8mm cap head screw
To install, you will need to drill a 2mm hole through the body in the desired location. Using the M2x8mm cap head screw, first install the printed washer onto the screw. Next, insert the screw through the body from the inside, and thread through the base and into the hatch handle.
Redcat parts on Thingiverse are released under the Creative Commons License Attribution- NonCommercial- ShareAlike 4.0 International (CC BY-NC-SA 4.0).
We want to share these parts with the world, and we want to inspire people to make and share their own parts for their vehicles.
In keeping with the non-commercial clause of this license, if you produce this part (Gen 8 Rear Hatch Handle.STL) + (Gen 8 Rear Hatch Handle Base.STL) + (Gen 8 Rear Handle Spacer.STL) for others, you may not receive compensation in excess of $0.15 per part, plus your shipping costs. This number is calculated based on an average estimate of material cost and machine running costs.