This corners fit to the black CTC (dual) printer.
Because CTC changed their laser cut artwork for the case parts several times. This corners fit to the version where the lowest side panel screws are located 25mm above the table where it stands on.
This corners are easy to attach. You just have to open 2 screws of the side panel and fix the corners with the same screws again.
- Now you only need side and front windows + a hood to be ready for ABS prints.
- The whole printer gets more stable because these corners support the printer framevery well.
- this corners don't touch/influence the drive linkage
You need 2 of each kind.
If you don't turn the corners to another side you can directly print them without raft or support.
They are not easy to print and your profiles have to match your used fillament and printer perfectly - because there are a some overhangs and sharp edges and combinations out of it. I printed them in ABS and PLA with different infill densities. very well.
For low infill rates use more shells to make sure the screws have enought material underneath.
But if you made it and it looks good you have well tweaked profiles and beautiful corners on your printer ;-)