These are windshield wipers for the Redcat Gen 8 International Harvester Scout II scale crawler.
Note: The STL file is for 1pc.
To install, you will need to drill a 2.2mm hole through the body in the desired location. The stem on the end of the windshield wipers will just press-fit into the holes. It's best to start out with a slightly smaller hole than necessary to ensure you don't make a hole too large for the stem to press into.
Redcat parts on Thingiverse are released under the Creative Commons License Attribution- NonCommercial- ShareAlike 4.0 International (CC BY-NC-SA 4.0).
We want to share these parts with the world, and we want to inspire people to make and share their own parts for their vehicles.
In keeping with the non-commercial clause of this license, if you produce this part (Gen 8 Windshield Wiper.STL) for others, you may not receive compensation in excess of $0.15 per part, plus your shipping costs. This number is calculated based on an average estimate of material cost and machine running costs.