printed on Anet A8 with 0.20 layer thickness and also on Fabpro1000 @ 0.050mm layer.
on any FDM be sure to use raft because the small feet don't give a lot of anchore point to support from.
If you flip it over so the supports are along the back of the dog it is easier to print (tip of ears and tail would be your 0.00 Z) but you will have a lot of support traces to sand off.
Scanned from live model
used my own dog as the model, this was digitized with the 3DSystems Sense Scanner, I then had a lot of adjustments & stitching to do with Freeform plus. I've printed this model with FDM printer using Cura to slice it and also on DLP using 3DSprint to slice it with no issues.
The original model was a male, but I did a bit of "digital gender modifications" to provide you with a female Dobe as well. I hope you enjoy and if you print please post your results.