Tired of digging sand out of your air filters? Caustic environments corroding your O-rings? Look no further! The Hazardous Environment Adaptation, Tank (HEAT) is the aftermarket essential your Imperial tank companies.
I know this works with the demolisher tanks, but I cannot check if it fits with the other hulls.
I run SLA so I almost always need supports. Not sure how FDM would do with this part but you're of course welcome to try.
There are 4 files contained uploaded:
HEAT.assembly.stl is a MONOLITHIC version with all parts - I haven't tested this yet.
Assuming you don't want to be a guinea pig, you will want to print the smaller pieces separately and assemble it after printing.
HEAT.exhaust.stl you will need 3 of.
HEAT.vents.stl is optional, need 2
HEAT.engine.block.stl is the main section, need 1.
Formlabs Grey Pro