Here's a VAS Minion Antenna (UFL) Mount for the 2019 Diatone R349, R249 and R239 canopy. So i created three options for this antenna Mount, because I read that TPU can block or change the 5.8Ghz by the time it gets to your goggles. I read on Facebook that Alex Greve (Creator of VAS Antennas) said that TPU does not cause video issues if an antenana is covered, but that is what someone posted so i'm not 100% positive TPU doesn't affect FPV frequencies since I did not see it posted directly from the expert Alex himself.
Ways to print:
Complete: Print the mount and base in one piece (You will need supports)
Print in two pieces: You need to print "Part 1 of 2" the base and only one of the three "Part 2 of 2" top portion that the VAS Minion fits inside. Directions are the same as posted in my original antenna "https://www.thingiverse.com/thing:3317546" (You will need supports for Part 2)
Here's the break down of the TPU coverage on the minion:
Full = Covers 80% of the Minion Antenna
Half = Covers 40% of the Minion Antenna
Min = Covers 20% of the Minion Antenna
FYI... If you have a Prusa I found that if you select the flex filament in PE Slic3r, and turn on the recommended settings in this Youtube video below my results turned out really good (Not perfect but close enough for me). One thing he didn't mention that will help with small parts like this one is to go to "Filament Settings" Tab and check the "Enable auto cooling" check box
Here's a good Video on printing TPU:
If you want to support me and my designs or maybe you cant print TPU. Then check out my eBay link as I'm selling these on ebay. Beside it helps motivate me to create and share more and gives me a little money for my hobbies.