Shim and optional screw standoff for Original Prusa i3 MK3 ENCLOSURE or derivative.
Check it out in the Customizer (look up and to the right) or download the SCAD file.
Print with whatever filament you like, maybe something that matched your corner pieces.
- 11 Jan 2019 - Fixed a bug that would make the part smaller than intended set by
corner_cylinder_r * 2
When trying to fit the plexiglass I didn't want to push to hard and damage a part, or or have the plexiglass bow in or out and put pressure on the parts or the Ikea Lack legs.
Perhaps one corner part I printed for the might have been a tad short in the Z-axis due to shrinkage. Or perhaps the Lack leg was a bit short.
The plexiglass measurement where right on and square.
I used some pieces of thin cardboard to measure the gap and pushed down on the corner to get an idea if I would be comfortable tightening it on a shim of that thickness. Then measured the cardboard with vernier calipers and print.
I decided to shims in all corners with different thicknesses.
I also didn't feel like searching for 6mm x 50 screws since i have a bunch of 5mm screws handy so I added an optional standoff. in the middle.