After half a dozen or so prints of TUSH that almost-but-not-quite worked, I decided to model my own variant that had the features I needed.
The pegs are drafted 3 degrees so they should never bind when you try to insert them into the bearing.
The hole in the pegs serves to stiffen the assembly and allow you to secure the halves together with an M4 if you find it printed just a little too loose.
Sized for 608 bearings. Should print with no support.
Print 4 of them. If you print them all at the same time you won't need "minimum layer time" enabled.
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.