Did this to use the empty spoolers I had around. Perfect for nuts and bolts or jewelry.
Half spool drawer and quarter spool drawer available.
Note: I have a xyz Junior 1.0 A which is not listed
Stepped 3 degrees de temp and used FAST mode.
Need to drill since the little notches (top ans bottom) on the spooler aren't aligned.
Did it in Tinkercad.
Modeled the spool and use it to cut a cylinder. Next, cut in half, duplicate, scale it a couple o mm end centered on the piece to cut it.
Added a peg to secure it to the spool and a hole on the other side to place a bolt.