Loading
CoreCreation

Spoolholder 608

by CoreCreation Feb 19, 2019
Download All Files

Thing Apps Enabled

Please Login to Comment

Great job here! I have my spool feeding the extruder from aside the printer, on the same table. Do you think this would work well anyway? Or might it fall over due to exteuder's traction? I might add an extension that connects to the side of the printer so that the filament should remain on the middle part of the spool.

Hello and thank you.
I do not think the holder or spool will fall over as long as the extruder and spool are approximately aligned and not offset by 90 °. The coil actually stays in the position you pushed it into. So an extension should not be necessary and run the filament in the middle of the extruder.
If changes should be necessary, just let me know, then I will make the .step file available for changes.

I'll print it on monday and report back my experience. Thanks!

That sounds good. Happy printing.

Hey I'm currently printing this holder (great job by the way!) could you tell me the dimensions of the bearings??

Thank you very much. I hope you like it. The outer diameter is 22mm. The inner diameter is 8mm and the thickness is 7mm. They are common bearings. Happy printing :)