GIRO - 608 Ball Bearing Y-Axis Idler

General

This idler was designed to be mounted on the Y-Axis of the TEVO Tarantula and uses 608 ball bearings. This idler is also usable for other printers with a 4020 extrusion profile as an axis. Please let me know if there are other printers where this idler also works. This Idler may be used with the stock Y-Axis carriage or other Y-Axis carriages by Mackers, Taralu or other manufacturers.

This Y-Axis idler is an addition to my designed 626 ball bearing X-Axis idler which is called GIRO - TEVO Tarantula / 626 Ball Bearing X-Axis Idler.

You will need additional screws, nuts and washers for the mounting of the idler. The needed parts are mentioned below.

Additional screws, nuts and washers
2x M3x35
4x M3 Washer
2x M3 Nut
6x M4x10 screw
12x M4 Washer
1x M5x35
2x M5 Washers
1x M5 Nut
2x 626 Ball Bearing

Printing

I would recommend to use 2 or more perimeters. Print with a lower speed, for example 30 mm/s, to get a more accurate printing. I recommend to print the idler with at least 50% Infill for the bracket and 100% infill for the pulley and pulley insertion.

Additional Information

Let me know if there are any kind of problems with the idler. I will try to help and if neccessary correct the designs. I appreciate any kind of feedback to this idler.

If you like my work and find it really usefull then I would be very happy if you give me a small tip as an appreciation for my work. For all of you who gave me a tip.