It wasn't fully success print, Infill overlap was wrong, so it has some lines of bubbles close to the shell. Im still working to improve quality of that types of prints.
I changed a little bit an original model by closing the air vents to the engine.
Also I recommend to print this at bigger scale, this one was printed at 140%.
Bigger scale= better quality. Also lowering the flow can make it better. In my case more flow causes some of the wing to disappear
PRINT-ME Swift PET-G
Printed with Swift PET-G Natural
Flow 101% or more/or less (It's hard to tell, you should try by you own what settings are the best)
Printing Speed 24mm/s
No cooling fan and retractions
Infill overlap is also important. I don't have the right amount yet but it's more/less than 6%
Sanded up to 12000 micro mesh and polished
It was printed in 140% scale