For printing Brackets.
Print at 2 shells, 15% infill.
No supports.(supports are included in model)
After printing, break away vertical support structures with pliers. Both the vertical structures, and the 45 degree supports near the top.
Clean off any burrs from the structures area
Slide the monitor into the bracket and fasten with short M3 bolts on both top and bottom. (Long bolts may interfere with the bearings on the center hole)
Indicator LED (on master - right side)
Blue - Not Armed (not armed until 1/4 encoder rotation occurrs)
Green - Movement Detected.
Yellow - Armed and Timing Out
Red - Timed Out, Triggering P-Stop
BOM and instructions on the main site.
Has external pins to attach additional equipment that might trigger a pause.