An alternative mounting block/cage to use E3D Lite6 hotends on the Anycubic Kossel printers. I designed this to use on my Anycubic Kossel Linear Plus, as the original mounting cage is too tall to use with a Lite6 - but it should also work on other Anycubic Kossel models which use the same metal cage to mount the hotend. It may also work for genuine E3D v6 hotends, though I don't have one to test with.
The top of the cage has a slot with a larger rounded end to allow installation and removal of the collet clip - but this does result in a small gap which the collet clip could slip through if dropped, so try not to drop it!
This is designed to print upside-down with no supports.
Warning: Using this cage to mount a Lite6 (or v6) hotend will probably result in your nozzle height changing! You'll need to adjust for this in some way, such as adjusting your build volume or Z offset to compensate for the difference.
I originally printed this with 20% infill as a test to ensure good fit, with the intention to print it with higher infill for actual use - but it turned out to be rigid enough that I haven't bothered to reprint it (yet) and have been using it for about a month with no issues.
Although I tapped the holes, you should be able to get away with simply driving the screws into them if you don't have suitably small taps - though it won't result in the threads being very durable.