This mount needs only 2 screws for the complete kit. It uses no adhesives and can be removed in minutes.
You will need:
(6) - Ultimaker_Dioder_Mount
(2) - Light_Bar
(1) - Logo_Back_Plate
(1) - Controller_Mount
1 - Put 2 Ultimaker_Dioder_Mounts on 3 LED strips.
2 - Put the top of the bracket on the top edge of the Ultimaker.
3 - Push the bottom under the bottom of the frame - it should snap into place.
4 - Put 2 screws into the bottom 2 holes of the ultimaker 10mm work best.
5 - Place the remaining Dioder strip into the 2 LIght_Bar_Mount.
6 - Tip the Machine back and screw the screws through the bottom of the Ultimaker and into the holes on the Light_Bar_Mount.
7 - Push the Logo_Back_Plate nob from the inside of the bottom into the "i" hole to hold it in place.
8 - Connect up all the wires.
9 - Enjoy.