Walking Dead Zombie - 45° Paintball Grips

by FreshPrints3D May 29, 2014
Download All Files

Thing Apps Enabled

Please Login to Comment

what printer did you make these panel grips on?

I printed them on a MendelMax 2, but they should print just fine on almost any single-extruder printer. You'll need to swap filament 4 times during the print though. Using 0.4mm layer height, you'll be swapping filament every 2 layers or so.

My best advice is is to Slice the model and then check it out layer-by-layer, so that you know exactly what layers you'll be pausing on. Then you can export the G-Code and add a pause command at each layer where you will need to change colors.