I liked the Phone Stand by GoAftens, and wanted to make a Hawk-themed stand. I used his basic design and added the hawk profile. I have two variants of the design. Both accommodate USB connections to the bottom of the phone, but one of them has a slot to hold a cable with a right-angle connector. I modeled this slot for this specific cable, but it will probably work for others as well.
Amazon Basics PLA
You will need to print this with supports. I printed this on its side with the hawk's head pointing to the build plate.
As can be seen in the images, the hawk wing extends into the phone stand using a negative space. You do not need supports for this area.
Carefully remove the supports. The beak on the head is fairly small. Be sure not to accidentally remove it along with the supports.
Fusion 360 for the basic shape (modeled after the design by GoAftens).
Affinity Designer to clean up the SVG for the hawk profile.