I printed these for my kids' bedrooms which included sizes 2-1/2"(63.5mm), 3"(76.2mm), &
3-13/16"(~97mm)(Center to center(Assuming everyone knows how to measure drawer pulls)).
I also created a drawer knob based on the same design.
All pull holes are 3.8mm(perfect fit for typical drawer pull screws).
All pull heights are 7/8"(22.2mm).
This design was a ton of fun and they spruced up my kids' rooms nicely.
Hope you enjoy.
Fluorescent Blue & Fluorescent Red
I printed a test set at 20% infill and it was more than sufficient, so I dropped it down to 10%, and they are more than strong enough.
One caveat to this design: the corners are very sharp. With that being said, I use my side cutters to snip the corners off each pulls' face. This is a product of being a novice in the 3D modeling realm. So, sanding/cutting/improvising is in my near future until I can figure out certain tips/tricks to make models exactly how I want them.