After looking at all the options for the CR-10 PRO and finding noting that works with he OEM parts with little to no modification, provides good part cooling, solid stable design with adjustable i re mixed part of the CR-10S and added what I new worked from y days at Valio building HVAC for cars and came up with these 3 parts.
To get this to integrate parts are printed first, then the hot end fan ins installed and then the pat cooling fan is adjusted to that it can be bonded to the side of the fan mount, The part cooling fan ring is setup so that if you make changes you have 2mm up and 2mm down adjustment.
Our CR10 PRP was a prototype sent to my wonderful friend and partner Alfred Shuryan At 3DPC.tech. I am in the process of re building and modifying the unit.
If you have a vent model pre 3/12/19 it has a small fit issue and has been updated as of 3/12/19
quantum 3d, Inland, ZYLtech & Tesla ABS
This may require longer screws to mount the hot end and fan in our unit I replace all the screws with studs and nuts
Fixent and surface treet
Acetone is not my favorite product and being in the composts industry we use a product called M.E.K. Solvent it will devolve ABS if you drop it in to the fluid and leave it there but if you apply with the a foam brush to the ABS printed part and MEK Solvent leaves a shine surface as the solvent evaporates.
As with Acetone care must be taken but unlike Acetone MEK Solvent is not going to damage your liver with exposure. Still should not to be used to clean your hands but it does much better then Acetone for ABS applications like bed prep and surface finish.