SKR V1.3 Case for Ender 3/Pro

by mtsgsd Mar 13, 2019
Download All Files

Thing Apps Enabled

Please Login to Comment

Will the Pro version fit Geeetech A10?

If fits perfectly, cables sit a bit on top of the tmc2208s, but I'm bad at cable management. The only downside is how hard it is to remove and insert sdcard. I have to lift the printer all the time to do it.

Did you have to extend any of the original cables for this case to work? I've printed the rear case but I really dont like it!

No, you shouldn't have to.

Get a Pi 3, then you won't need the SD card reader. Coz you will add WiFi and much more.

Really well done, love how the cover fits! SD card is kinda hard to use (i have to tilt up the board) since its pressed right up against the y-axis, but it's a good compromise (other boxes tend to go way below the stock 'height', requiring feet).

It is me, or is this backwards for an Ender 3? This would actually be for the right hand side next to the display. Oh wait, I see. Your mounting the board upside down.

Correct. This is because of the direction the usb and sd card ports face.

Printed for and Ender3.
The bottom part will fit the case but you can't screw the part to the aluminum frame
Z stop and bed sensor cables need extension
The position of the SD card is very uncomfortable and impossible to use
Other than that the fan position and mounting system are OK

so the board will be hang up on the top side??

Anyone tried and confirm this fits SKR v1.3 with access to SD Card?

I'm using it right now.