New version of my chain mount to NEMA stepper motor on Z axis.
dit print 4 versions of them and came with this version V5
Fitting is nice and thight.
take care to fit chain to it and carfull mount to nema do not stress the noches
When i printed this i printed it with the chain side to top (cable hole up)
so you get more strength from the lines inside.
the first versions where not strong with 20% infill , did use 100% on V5
Ongoing design, needs to change the notch , not strong after printing...
wait with printing soo i have a new version.
if the mount do not click on nema because of the high,
you can remove 1 mm in the centre, ( its there on purpuse.)