Simple angled laptop stand for my Macbook Pro. Wanted a sharper angle to take up less deskroom. Will likely support other laptops -- the gap between vertical supports is 17mm.
Inspired by this design but rebuilt in Tinkercad. I wanted to round out the leading edges and provide additional support to the rear support. Slimmed and widened the base.
Used printer settings inspired by this Makers Muse https://www.youtube.com/watch?v=3kW9SnK4LKc video.
In case it's not obvious, you'll need to print two of these :) Each took about 1.5hr using 'Stupid Fast' settings.