A fairly simple but chunky LCD mount for my WIP, printer re-vamp.
designed to go on the top back edge of the case/box
Made from 18mm MDF.
Parts are made with Farnell's inexpensive PLA
Very impressed with the filament (Real impressed - NO Stringing at all)
Note the pictures show a gap between the shoulder and LCD PCB,
I have fixed this in the STL, but i have not re-printed it yet.
Farnell / Multicomp PLA
2 - 3 walls
All I needed to do was remove the skirt/brim,
and use a M3 Tap to start the thread (you can just force an M3 bolt in, if you don't have a Tap set ... you relay should get a set, even if it is a cheep one)
You will need two M4 nut's, to squeeze between the two PCB's of the screen.
I also fitted a washer between the bracket and the PCB,
I recommend just using a soldering iron to cut a little grove for the solder joints.