Note: This is for the TL Smoother Plus. The one that says trianglelabs on the back. Print laying flat as shown in pictures.
After downloading a lot of TL Smoother Plus case designs, I couldn't help but notice how bulky the cases were. I simply wanted a minimalist design that I could slip into the mainboard box that would prevent anything from possibly getting short circuit while allowing my TL smoother(s) to stay cool. That means plastic plugs don't need to be covered by more plastic like the other designs are doing.
- Low profile. Adds 1mm to each side of the board. case height is lower than plugs.
- Only 4g of plastic total per case + lid
- Vents on all sides so smoothers stay cool even if cases are stacked
- 6 Clips so case stays nice and tight.