ITS BIGGER, IT HOLDS MORE DICE, ITS VERSION 7!!!
This Version Mods...!
- Holds 8 sets of 7 dice Comfortably!!! (cause we need more dice dammit!)
- Holds 4 Mins (25.4mm bases)!!!
- The Pencil area has been moved to a slide draw with magnets to the side of the box!!!
- The Tablet Stand has a Attachment for a portable Battery Charger!!!
Machine and Printing Settings:
Machine: Cocoon Create Touch (Wanhao I3 Plus) - 200x200x180mm
(you will need a bed of at least 200X200mm to print this!!!)
Amount of Plastic used: 75 - 80% of a 1KG roll of PLA (including support material)
Nozzle: 0.4mm @ 195C
Layer Height: 0.2mm
Bed: 60C - for the larger prints, A thin layer UHU glue stick helps!
Infill: 15% - if you go lower in %, (eg 10%) you will need to increase top layers to 5 to
remove Bumps. on the slide lid, 100% infill is best!
Walls: Top 4 to 5 - Depending on your infill! above 20% around 3-4 is fine!
Walls; Bottom - 2 to 3 layers.
Walls: Sides - i used 2 on mine.... Ive had no issues for 3 weeks now! 3 would be ok, 4 is
wasting time printing and plastic.
Material: PLA is fine. ABS if your more daring! lol
The Tablet Stand was Slightly edited in Tinkercad to put holes in the back for the magnets
(Original Stand Design - https://www.thingiverse.com/thing:1769212)
Thanks to https://www.thingiverse.com/jamesarm97/ for the Tablet Stand Design!!!
You will need 20 1X3mm Magnets for this build - Cheap of Ebay!
- - - NOTE: THIS IS A COPYRIGHT FREE DESIGN!!! - - -
MEANING: YOU CAN MAKE, MODIFY AND SELL WITHOUT INFRINGEMENT!!!
Happy Gaming - Berko
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/8T0TEk0B32e