This is a table press which can exert quite a bit of force. It can be used to press in ball bearings, bushings, pins and the like. Fast adjustment is made by the use of knobs with inserted nuts. The force is then applied to the plunger by an excenter mechanism built in the levers. Total travel distance of the plunger is about 10mm. Usable clearance between the threaded rods is 90 mm.
You can add attachments to the plunger or the bottom plate via M4 bolts or you can print your customized parts (dies).
For example you can make christmas tree ornaments out of rusting sheet metal by twist bending it in a contraption as shown in the pictures. This gives your tree the heavy duty look.
For the full customer experience I suggest to print it with yellow filament :)
1x lever right
1x lever left
1x top plate
1x bottom plate
2x threaded rod about 120mm long
8x nut M10
2x washer M10
2x bolts M5x50 inner hex
2x nut M5
rubber rings to keep the plunger in place
anti-slip pads if you like