Loading
joachim67

Duplo to Brio connector (small)

by joachim67 Jun 2, 2014
Download All Files

Thing Apps Enabled

Please Login to Comment

Hi,

I just printed @hanst's model and then seen your remix.

How is that suportless? Doesn't the first "base" layer need suport too? I'm looking at that with cura and don't see how that would hold…

Maybe I should be testing it instead but my printer is reeeeally slow ^^

Thanks!

Hi,
I'm not quite sure if you mean support or raft. If your print comes off from the bed during printing, then you should enable a raft, or use other techniques that improve stickiness.
Support would be needed if there are overhanging parts that overhang with a certain angle. This part I designed so that the overhanging connector has a rather steep angle, where most printers manage without support. But if you get better results with support, enable it. But I would try without support first.
Joachim

Hi,
Thanks a lot for having improved Hanst model, this is a very nice improvement.
Please note that Hanst model is under CC-BY-SA licence, it seems that you have to put your remix under this licence too (SA means share alike, you have to add the SA part and remove the NC part). What do you think ? Could you please change the licence ? (except if you really want to keep the NC part and have the authorization of Hanst and the previous author as for example Flummer).
Thanks again for having improved this model and published it here.
Regards