Loading
Spodesta

Petsfang V2 adapter body for E3D Volcano on CR-10s Pro with ABL mount

by Spodesta Mar 23, 2019
Download All Files

Thing Apps Enabled

Please Login to Comment

Hey Spodesta, and thanks again for providing all this. However, I tried flashing the firmware to my CR10S Pro (Marlin.ino.with_bootloader.mega.hex) just the same was as I did with the Tinymachines3d firmware a while back, and it failed on me. I'm pretty confident this was an issue on my end, but my problem now is that the CR10S Pro is only booting to the Creality logo screen and not loading up at all. I've tried numerous times to power off and back on, flash tinymachines3d back onto it, etc and it just gives me the following error in slic3r PE (what i use for my prusa and creality printers):

Using Port : COM2
Using Programmer : wiring
Overriding Baud Rate : 115200
avrdude-slic3r: stk500v2_recv(): timeout
avrdude-slic3r: stk500v2_getsync(): timeout communicating with programmer
avrdude-slic3r: Could not open port: COM2

Any help or insight you may be able to provide would be greatly appreciated. Thanks again!

Hello RustedLongsword,

I'm sorry to hear you are having trouble.

I Flashed the firmware using Arduino IDE and compiled the hex from there, make sure to disconnect the USB cable from the machine before rebooting. The baud rate that works for me and is set in the firmware is 250k.

Let me know how it goes, good luck!

Just updating since I fixed my issue - I just had to reflash the bootloader, then load the firmware back on and it's back to working!

All is well! :)

Will this also work on the cr-10?

Not with this part, the x axis rail is different on the CR10s pro and the CR10. But there is an official adapter for the cr10 on the Petsfang thing page. Good luck!

Hello, have you the 3d for cad? I will make a mount for E3D V6. Thx

Is now added!

Comments deleted.