Loading
JuanPuchol

Zaribo Y-Axis Linear Rails 15x15

by JuanPuchol Mar 23, 2019
Download All Files

Thing Apps Enabled

Please Login to Comment

Hola, a ver si me puedes aclarar una duda. Por las fotos evidentemente esta montado y entiendo que funciona, sin embargo la distancia entre tornillos de las piezas de los patines para unirlos a la cama es de 21mm (entre centros) mientras que en todas las "arañas" o "h" que encuentro de mk3 hay 20mm.

Hola, perdona por la tardanza pero estaba de vacaciones. Tienes razón debe ser 20mm la distancia correcta, ya está corregida y los archivos actualizados. De todos modos como has visto con 21 también funciona.Gracias por avisarme.

Is it possible to adapt motor holder and Y tensioner holder to V-slot for Prusa Bear ?

Sorry for the delay, I have enlarge the heatbed belt holder by 10mm (easier than modify the other parts)

Ok, thanks. I will test it.

Also I have a problem with the double support for HGW15CC. I have attached more photos with the other comment.

Can you help.me with 15CC blocks?
I don't know how to modify step 3d files...

Hello, I did this HGH15CC block, please try it, if it's correct I will adapt the double block

Great. That`s what I needed, only the screw holes, that I need M5 screws instead of M4 (But I can drill it a little bigger)
Can you adapt the double block? Thanks so much!

M5? The HGH15CA block uses M4. I can change it to M5, but I thought the HGH15CC used M4 (the HGH15CC diagram shows M4)!!!

Sorry Juan,

It is my fault, I am using HGW15CC, and not HGH. HGW uses M5 screws but I think is the same block size as HGH.

Don't worry, I just wanted to be sure. Here you have both blocks with M5 (holes) bolts. Please check them because I will publish them.

More photos, because the double block is not valid. It is higher than simple one, because it doesn't fit correctly in the block

They are just a little bigger (2mm) from one bed base support to another. Please take a look at this photo.

Thanks a lot for your great job!

Ok, thanks so much. I will print it today and test it as soon as possible.

Hello, what do you need?

Good Work!

Can you help me adapting this design, to HGW15CC blocks ???

Thanks!

Comments deleted.