The mount is now tested and updated with new screw holes to make mounting stronger, plus a new V2 option that has a more open design and of course uses less plastic and time
I needed a way to mount my Anker Power Port 5 to the bottom of a desk in the shop.
After looking at a few other options I decided I would make my own option (the wonders of 3D design and Printing)
This should fit snug allowing enough space for the charger, also both ends are the same so it can be mounted in any direction you like, also added some air holes as I know these can get a little warm as they are much higher amps than a normal USB charger especially if you have 5 devices all charging at once.
If you find any issues please feel free to comment.
rigid ink pla
All of these settings are easily changeable to your liking, but if printed as designed it wont need any supports, you may only get a very small issue where the screw holes are but that can be easily cleaned up if needed.