Insert adapter into housing.
2.Inserted and push in end stop until adapter is snug. Insert following the direction arrow to allow ratchet to work.
3.Tidy excess ribbon cable with an elastic band leaving 50mm to allow the end to be folded by 90 degrees.
4.Carefully insert Micro SD jack into appropriate slot.
5.Fix to lid via 2 x existing M3 hex bolts.
The main body is printed vertically and does not need any supports. Dependent on build surface it may need a raft, all my prototypes worked fine without any raft.
Printed @ 0.2 resolution and 20 % infill Printed on a Ender 3 & Ender 5.
More from 3D Printer Parts
Save to Dropbox
If you’re logged into Dropbox, you can save directly to Dropbox.
Show Some Love
Say thanks by giving BoothyBoothy a tip and help them continue to share amazing Things with
the Thingiverse community.
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.