I'm learning TinkerCAD and my GF had shown me a photo of this and had asked if I could make it. It didn't turn out half bad!
I printed each jewel in a different color and to make sure it successfully printed the small jewell I printed each on a raft. Each jewel printed fine on the first try at 0.080mm 100% infill.
I printed the brooch at 0.100mm 50% infill.
Theres also two clips included, if you're clipping this on a thin shirt, use the small one. and if this is clipping to a costume where there could be thicker fabric to clip to, use the large clip.
I hope to see someone at a con one day wearing this!
Please post MAKES!!!
Follow @wcphotome on IG for
Rafts only needed for the jewels. Jewels printed at 0.080mm 100% infill.